Installing Openwrt On A Mikrotik Routerboard

It does however also mean that there is a second step if you want OpenWrt to persist: since you did already netboot into OpenWrt, we can use its sysupgrade command instead of a vendor-specific firmware update mechanism to do the actual flashing. Ing Openwrt On A Mikrotik Routerboard Upgrade Command Instead This is not a recovery mode as in the TP-Link routers where the firmware retrieved over the network doesnt become active until after having been written to flash in fact, with the MikroTik bootloader, it doesnt get written to flash at all but runs right out of the RAM, similar to PXE booting on your x86 PC. This sounds worse than it is, so far I have not had any trouble with development snapshots. This is due to a changed model string in the flash: proccpuinfo s model string shows RouterBOARD RB941-2nD instead of RouterBOARD 941-2nD as with older routers (notice the two letters RB). However at least on my units purchased in March 2019, I got struck by a missing wan interface because the switch was not setup correctly. If you have one of the first RB941-2nD-TC routers manufactured, this might apply, too. The page has not yet been updated to this regard. This is outdated information as you can just use one of the provided images on just fine.

Should you ever want to go back, it would have been a good idea if you backed up that license beforehand. I tried to reflect this in the OpenWrt Wiki as well but maybe you prefer a consistent blog post, at least Id do so, so here you go. Ing Openwrt On A Mikrotik Routerboard Upgrade Command Instead.

Installing Openwrt On A Mikrotik Routerboard