Note. In firmware version R01.08.32 the following error was corrected by Motorola: USB Read/Write error when used with Windows OS (predominately Windows 7). The required firmware version for DP/DM 3000 is 'R01.08.32' or higher The required firmware version for DP/ DM 4000 and SL radios is «R02.00.00» and higher. Specify Metric 500 for MOTOTRBO Radio Network ConnectionĪll MOTOTRBO radios and repeaters working in the radio system must use the same firmware version.

Select Internet Protocol Version 4 (TCP/IPv4) and click on Properties and then Advanced. In the network connection properties of MOTOTRBO, which is created automatically at connecting the control stations to the computer via USB, disable all the interfaces except for TCP/IP v4. Make sure MOTOTRBO Control Station is installed properly on the computer where the radioserver is installed (MOTOTRBO Radio connection should appear in the state Connected in the Network Connection Properties window). (Right-click on Computer icon and select Manage. In the list of System Toolsselect Device Manager abd click on Network Adapters and see MOTOTRBO Radio connected)Ģ. MOTOTRBO Radio in Network Connections List MOTOTRBO Radio should appear in Device Manager Window. Make sure that MOTOTRBO Control Station is installed properly on the computer where SmartPTT Radioserver Configurator is installed.

But for some reason I cannot read it in MOTOTRBO CPS Software I tried contacting Motorola for support, but they said they've dropped everything for the XTS series last year.I connected Control Station via USB cable to the PC. I did uncover an old Win2K config laptop with an older version of CPS, but it says my radios' codeplug is too new for it. May have to try digging around to find a Windows 7 machine to do my configuration. I have tried basic compatibility mode in Windows 7, to no avail.ĭoes anyone know about compatibility with CPS and Windows 10? I'm not sure if it's an issue with the drivers for the radio/cable, or what. I am waiting on a colleague at another location to send me the R20 disc, in hopes that will work better than R17. I get the device connected/disconnected tone from Windows, and don't see any devices with errors in device manager. Please check the connection and try again!' If I try and read direct from the USB, I get the error 'Radio is not detected from USB port. I am presently using R17.01.02 with an RKN4105A USB cable, setting the COM port to the virtual one assigned to the USB (in this case COM4). All of our computers have been upgraded to Windows 10, and I seem to be having some issues namely, I get the error 'Radio Baud Rate could not be set Error Context: 24, Status: c000038'.

I need to do a reprogram for a fleet of radios, but I haven't used CPS since we were on Windows 7.

Motorola cps software windows 10